John Bean B 1200P Manual De Operador página 118

8
118
5-71
5-72
5-73
5-74
Operation
Reading of error code E9
If E9 is read out, at least one error was made with
respect to the sequence of operations when performing
optimisation (System messages
— Abort the optimisation program by pressing the
STOP key and, if desired, start optimisation once
again.
Fig. 5-71 OPTIMISATION "12"
(4th measuring run of tyre/rim assembly)
— Clamp the wheel on the balancer.
— Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
— Confi rm the valve position by pressing key 8.
The OPTIMISATION "13" screen (Fig. 5-72) is
displayed.
Fig. 5-72 OPTIMISATION "13"
START is displayed on the screen.
— Spinn the wheel.
A measuring run is performed.
The BALANCING screen (Fig. 5-73) is displayed.
Finish weight Optimisation
Fig. 5-73 BALANCING
— Balance the wheel according to the readings.
Fig. 5-74
If the wheel running conditions are optimal, the
following codes can be displayed:
H0 Wheel running conditions cannot be improved by
optimisation.
H1 Further optimisation not recommended but
feasible.
H2 Weight minimisation is recommended, optimisation
can achieve no further improvement.
F
7.1).