John Bean B 1200P Manual De Operador página 68

1
68
5-30
5-31
2
Operation "PROFILING"
5.5 "PROFILING" balancing
The following instructions describe the specific
functions of the wheel balancer in PROFILING mode.
The icon (1) shown in figure 5-30 indicates the
PROFILING mode is active. The unit operates in
Automatic Mode.
When the "PROFILING" mode is set with the set up
panel, the machine performs the automatic wheel
data reading procedure and the user does not have to
perform any setting before the measuring run (except
for Type of Vehicle, if a different type of vehicle from
the one set needs to be retrieved; i.e. Car).
This section sets out the specifi c functions of the
"PROFILING" mode and only the Menu items that
refer to this mode.
For information about the other items and icons, refer
to the basic chapter "4. Control Elements".
During the wheel measuring run the screen in fi gure
5-31 appears and at the end the weights shown can be:
- suggested (yellow)
or
- possible alternatives (grey).
If the Spokes Count is active, the icon (2, Fig. 5-31) is
displayed during the measuring run.
The possible application of the weights in ways
other than that suggested by the machine is
indicated by the grey weights in the positions
compatible with the rim configuration detected.
Note:
The change in the position of the weight is saved by
the machine, then automatically suggested for all
subsequent wheels with the same dimensions. The
selection is deleted when the machine is switched off.