Troubleshooting - Yamaha YBA-10 Manual De Instrucciones

■ Troubleshooting

Check the following if this unit should not be operating properly (if noise is output or if the unit
malfunctions):
Incomplete connection
The device with which you are trying to exchange
signals is not compatible with A2DP or AVRCP.
The device with which you are trying to exchange
signals and this unit are too far apart.
There is an obstacle between the device with which
you are trying to exchange signals and this unit.
There is a device emitting electromagnetic waves in
the 2.4 GHz band nearby (microwave oven, wireless
LAN device, etc.).
Pairing has not been properly performed.
The device with which you are trying to communicate
is not sending Bluetooth signals to this unit.
Cause Remedy
Check the connection of the YBA-10 compatible
component (AV receiver, etc.) and dock connection
cable.
Check the connection of this unit and dock connection
cable.
Use an A2DP or AVRCP-compatible device.
Install in the same room within a line-of-sight
distance of 10 m (33 ft) and with no obstacles.
Move this unit away from the device.
Refer to the operating instructions of the YBA-10
compatible component (AV receiver, etc.) and
perform the pairing operation over.
Check whether the device with which you are trying
to communicate is properly set.
5
En