Playback; Basic Connections - JVC GR-DV1 Manual De Instrucciones

44
AC OUTLET
AC POWER ADAPTER/CHARGER
POWER CORD
Docking Station Attachment
When you attach your camcorder to the optional Docking Station, you can add many interesting effects
during playback.
1
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2 PLACE CAMCORDER IN DOCKING
STATION
If you plan to use the MENU button while the
camcorder is docked, you need to pull out its
viewfinder before attaching.
3 ATTACH AND LOCKS
Press down on the camcorder and slide the
Lock Lever in the direction of the arrow. The
camcorder and the Docking Station are now
securely attached.
• Make sure that the camcorder does not have
a DC cord or an AV cable connected to it
before attaching.
• When removing the camcorder, press the
Release button and lift the camera out.
4
SUPPLY POWER
Connect the optional AC Adapter between the
Docking Station and an AC outlet.
• The Docking Station cannot function using
the camcorder's battery.
TO DC INPUT JACK
MULTI JACK
TO DC JACK
5
Using The Remote Control During Playback
Once the camcorder is attached to the Docking
Station, you can use the RM-V708U remote control
for regular playback, slow motion
(approx. 1/10 speed–
(
Charging The GR-DV1 Battery
If you attach the camcorder with the battery
installed to the Docking Station, you can charge the
battery. Set the Power Dial to "OFF", then perform
steps 1 through 4 of the Docking Station Attachment
procedure. The Docking Station's charging lamp
starts blinking to indicate that charging has begun.
When it stops blinking but stays on, charging is
complete. It normally take approximately 170
minutes to charge using this method.
•Do not attach or remove the battery while the
camcorder is attached to the Docking Station.

PLAYBACK

Basic Connections

POWER DIAL
LOCK LEVER
DOCKING STATION
SELECT MODE
Set the Power Dial to "PLAY".
pg. 45), Playback Zoom
pg. 50), and P.AE/Effects (
RELEASE BUTTON
pg. 51).