Basic Playback - JVC GR-DV1 Manual De Instrucciones

PLAYBACK

Basic Playback

You can watch what you've recorded in the viewfinder.
OFF
5S
POWER DIAL
OPERATION PANEL
COVER
1 SELECT MODE
Pull out the viewfinder and set the Power Dial
to "PLAY".
2 OPEN COVER
Slide the camcorder's Operation Panel cover
as shown in the illustration.
3
REWIND TAPE
Press REW. If you rewind all the way to the end
of the tape, it stops automatically.
4 WATCH RECORDING
Press PLAY. You can watch the recording in the
3
viewfinder.
5
END PLAYBACK
Press STOP and set the Power Dial to "OFF".
To Perform High-Speed Search . . .
..... press REW or FF after pressing PLAY. The tape
will move at approximately 9 times the normal
playback speed. Watch in the viewfinder and,
when you reach the spot you want to see, press
PLAY and normal playback resumes.
POWER
LAMP
NOTES:
You can also perform a High-Speed Search by
pressing and holding REW or FF during the PLAY
mode. The search continues as long as you hold
the button. Once you release it, normal playback
resumes.
A slight mosaic effect appears on screen during
High-Speed Search. This is not a malfunction.
The sound is not available during High-Speed
Search.
Still Playback
To temporarily stop playback, press PAUSE. Press
again to resume playback. If still playback
continues for more than about 3 minutes, the
camcorder's Stop mode is automatically engaged.
After 5 minutes in the stop mode, the camcorder's
power is automatically turned off.
47
REW
RE SHOOT
PLAY
/PAUSE