JVC GR-DV1 Manual De Instrucciones página 63

SYMPTOM
18. The Picture Wipe function
doesn't work.
19. Even when Slow (Slow
Shutter) isn't selected, the
image looks like it is
activated.
20. The Video Echo effect
doesn't work.
21. There is no strobe when
the Classic Film and
Strobe effects are
activated.
22. White Balance cannot be
activated.
23. The viewfinder indica-
tions blink.
24. There are disturbances in
audio and video.
25. An unusual mark appears
in the viewfinder.
26. An error indication
(E01 — E07) appears in
the viewfinder.
POSSIBLE CAUSES
18. •The Slow (Slow Shutter)
effect is activated.
•The Squeeze or Cinema
mode is selected in the
Recording Menu.
19. •When shooting in the dark
with GAIN UP set to A
unit becomes highly sensitive
to light and the image takes
on an effect similar to Slow
(Slow Shutter).
20. •The Picture Wipe or
Dissolve functions are in use.
•The Squeeze mode is
selected in the Recording
Menu.
•Snapshot Dissolve is in
progress.
•A Fade-In or Fade-Out is in
progress (White Fader, Black
Fader or Black & White
Fader).
21. •The Picture Wipe or
Dissolve functions are in
use.
•Snapshot Dissolve is in
progress.
22. •The Sepia or Monotone
effects are activated.
•Snapshot Dissolve is in
progress.
23. •Certain FADE/WIPE, P.AE/
Effects and other functions
that cannot be used together
are selected at the same
time.
24. •If Audio Dubbing or Insert
Editing have been performed
repeatedly on the same
portion of the tape,
disturbance to the sound
and picture may result.
25.
————
26. •A malfunction of some kind
has occurred. In this case
the camcorder's functions
become unusable.
CORRECTIVE ACTION
18. •Make sure the Squeeze
mode, Cinema mode, or
Slow effect is not activated
when preparing to use the
Picture Wipe function.
19. •If you want the lighting to
, the look more natural, set
GAIN UP to "AGC" or
"OFF" in the Recording
Menu.
20. •Make sure the Squeeze
mode is set to "OFF".
•Do not try to use the Video
Echo effect during a
Fade-In or Fade-Out.
21. •Do not try to use the
Classic Film or Strobe
effects during a scene
transition.
22. •Turn off Sepia or Monotone
before setting White
Balance.
•Wait until the Snapshot
Dissolve is finished before
setting White Balance.
23. •Re-read the sections
covering FADE/WIPE and
P.AE/Effects
( pg. 31, 36).
24. •Use a new, or infrequently
used, tape for Audio
Dubbing and Insert Editing.
25. •Check the section of the
manual that explains
viewfinder indications
( pg. 66).
26. •Remove the tape or the
battery pack, and wait a
few minutes for the
indication to clear. When it
does, you can resume using
the camcorder.
If the indication remains,
please consult your nearest
JVC dealer or Technical
Service Center.
63