Loading/Unloading A Cassette; Recording Time - JVC GR-DV1 Manual De Instrucciones

Loading/Unloading A Cassette

If you have already installed a fully charged battery, you can open the door without external power.
CASSETTE HOLDER
CASSETTE COVER
1 OPEN CASSETTE DOOR
Turn on the power, then slide the OPEN/EJECT
switch in the direction of the arrow. The
cassette cover releases. Open the cover in the
direction of the arrow until it locks. The holder
opens automatically.
•Do not touch internal components.
2 INSERT/REMOVE TAPE
Insert or remove a tape and press "PUSH" to
close the cassette holder.
•Once the cassette holder is closed, it recedes
automatically. Wait until it recedes
completely before closing the cassette cover.
•When the battery's charge is low, you may
not be able to close the cover. Do not apply
force. Replace the battery with a fully
charged one before continuing.
TAPE
DVM 30
DVM 60
PUSH

RECORDING TIME

Approx. 30 min.
Approx. 60 min.
OPEN/EJECT SWITCH
Make sure the window side
is facing out.
NOTES:
It takes a few seconds for the cassette holder to
open. Do not apply force.
If you wait a few seconds and the cassette holder
doesn't open, close the cassette cover and try
again.
Be careful not to get your fingers caught in the
holder when it's closing. If this happens, the
holder will open automatically after a few
seconds.
When the camcorder is suddenly moved from a
cold place to a warm environment, wait a short
time before opening the cover.
** To protect valuable recordings . . .
..... slide the black switch on the back of the tape in
the direction of "SAVE". This prevents this tape
from being recorded over. If you decide later that
you do want to record on this tape, slide the
switch back to "REC" before loading the tape.
15