Viking ME 545 Manual De Instrucciones página 36

Do not work at ambient temperatures
below +5°C (41°F).
Do not operate the machine in the rain or
during thunder storms, particularly when
there is a risk of lightning strike.
The risk of accidents is higher if the ground
is damp due to increased danger of
slipping.
Particular caution should be exercised
during working in order to prevent slipping.
If possible, avoid using the machine when
the ground is damp.
Do not leave the machine in the rain.
Switching on the machine:
Exercise care when switching on the
machine and observe the instructions in
the section "Initial operation of the
machine". ( 11.)
Keep your feet a safe distance from the
cutting tool.
Place the machine on an even surface
before switching it on.
The machine must not be tilted before it is
switched on or during switching-on.
Do not switch on the motor if the discharge
chute is not covered by the discharge flap
or the grass catcher box.
Avoid switching the machine on repeatedly
within a short period of time; in particular
avoid "playing" with the ON button. Risk of
motor overheating.
Working on slopes:
Always work across and back on slopes,
never up and down.
If the user loses control when mowing up
and down, there is a risk of being run over
by the machine.
Be particularly careful when changing
direction on a slope.
34
Always ensure good stability on slopes
and avoid mowing on excessively steep
slopes.
For safety reasons, the machine must not
be used on slopes with an inclination of
more than 25° (46.6%). Risk of injury!
A slope inclination of 25° corresponds to a
vertical height increase of 46.6 cm for a
100 cm horizontal distance.
Working:
Caution – risk of injury!
Never place your hands or feet
on, underneath or above
rotating part. Never touch the
rotating blade. Always keep away from the
discharge opening. Always observe the
safety distance provided by the handlebar.
Do not try to examine the blade
while the machine is operating.
Never open the discharge flap
and/or remove the grass catcher box when
the mowing blade is running. Rotating
blades can cause injury.
Only operate the machine at walking
speed – never run when working with the
machine. Working quickly with the
machine increases the risk of injury due to
stumbling, slipping, etc.
Be particularly careful when turning the
machine around or pulling it towards you.
Risk of stumbling!
Never lift or carry the machine with the
motor running or the mains lead
connected.
Objects hidden in the turf (lawn sprinkler
systems, posts, water valves, foundations,
electrical wires, etc.) must be avoided.
Never run over any such foreign objects.
Use the machine with great care when
working near slopes, terraces, ditches and
embankments. In particular, ensure that
you maintain sufficient distance to such
danger areas.
If the cutting tool or the machine hits an
obstacle or a foreign object, the motor
must be switched off, the power cable
disconnected and an inspection performed
by a specialist.
Beware of the cutting tool
running on for several seconds
before coming to a standstill.
Switch off the motor,
– if tilting of the machine is necessary
when transporting over surfaces other
than grass,
– when pushing the machine to and from
mowing areas,
– before removing the grass catcher box,
– before adjusting the cutting height.
Switch off the motor, disconnect
the mains plug and ensure that
the cutting tool has come to a
complete standstill
– before remedying blockages, including
those in the discharge chute,
0478 121 9909 H - EN