Adjusting The Self-Propulsion Cable (Me 545 V); Transport; Minimising Wear And Preventing Damage - Viking ME 545 Manual De Instrucciones

12.9 Adjusting the self-
propulsion cable (ME 545 V)
Maintenance interval:
As required
The tension of the cable is adjusted
correctly at the factory.
Adjustment of the cable is necessary
– if, after a lengthy period of use, self-
propulsion does not engage properly
when the self-propulsion lever is
actuated.
– if self-propulsion is permanently
engaged. – This means that the lawn
mower automatically begins to move
when the machine is switched on,
despite the self-propulsion lever not
being actuated.
Risk of injury!
The self-propulsion cable must be
correctly adjusted before the
machine is operated. If necessary,
consult a specialist dealer. VIKING
recommends VIKING specialist
dealers.
Checking the cable tension:
● Switch off the motor and remove the
mains plug.
● Actuate the self-propulsion lever while
pulling the lawn mower backwards.
The drive wheels must lock after
approx. one third of the lever travel.
Adjusting the cable:
● The cable tension is increased by
turning adjustment screw (1) on the left
on the upper handlebar in the "+"
direction and reduced by turning the
screw in the "–" direction.
0478 121 9909 H - EN
12.10 Storage (winter break)
23
Store the machine in a dry and locked
place that is generally free of dust. Make
sure that it is kept out of the reach of
children.
Only store the lawn mower in good
operating condition, fold down the
handlebar if necessary.
Keep all nuts, pins and bolts tightly
fastened, replace danger signs and
warnings on the machine that have
become illegible, check the entire machine
for wear and damage. Replace all worn or
damaged parts.
Any machine faults must be completely
remedied prior to storage.
Note the following points when storing the
lawn mower for long periods (winter
break):
● Clean all external parts of the machine
with care.
● Thoroughly lubricate/grease all moving
parts.

13. Transport

13.1 Transport
Risk of injury!
Observe the section "For your
safety" before transporting. (
Always wear suitable safety
clothing when transporting (safety
shoes, thick gloves).
Always disconnect the power cable
before lifting or transporting.
Carrying the machine:
● Only hold the machine at
carrying handle (1) and at
handlebar (2). Always ensure sufficient
distance between the mowing blade
and your body, particularly your feet
and legs.
Securing the machine (lashing):
● Secure the machine on the load
floor using suitable fastening
material and transport upright on its 4
wheels only.
● Attach ropes or straps at upper
housing (3).
14. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
lawn mower, manually-operated and
mains-powered (ME)
VIKING assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
4.)
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
24
25
43