Braking; Adjusting The Cutting Height - Viking MR 4082 Manual De Instrucciones

The engine should be switched off in
the following sequence:
● Brake the machine to a complete
standstill.
● Disengage the mowing deck. (
● Press the brake pedal to the stop and
hold. ( 8.8)
● Set the throttle lever to the
MIN position. ( 8.2)
● Turn the ignition key to the "engine
off"position. The engine stops.
● Engage the parking brake if necessary.
( 8.9)
● The foot can be removed from the
brake pedal.
● Close the fuel cock if necessary.
( 13.14)
● If required, remove the ignition key and
keep in a place where only authorised
persons can access it.
11.4 Driving
Warning:
Before driving the machine,
carefully read and observe the
section "For your safety". (
A low driving speed must always be
selected on rough terrain.
Before each change of direction,
especially on slopes, the driving
speed must be appropriately
reduced.
Only regulate the driving speed via
the drive pedal at maximum engine
speed.
90
The following points must be noted
before driving:
● Always check the braking function
before driving.
8.3) ● Engage the gearbox freewheel lever.
( 8.13)
● Bring the machine to a standstill and
only then actuate the driving direction
selector lever.
Forward driving:
● Start the engine. (
● Set the throttle lever to the
MAX-position. (
● Set driving direction selector lever to
front position (forward driving direction).
( 8.4)
● Disengage the parking brake, if
engaged. (
● By pressing the drive pedal, the driving
speed is regulated and the machine
moves forward.
Reversing:
● Start the engine. (
● Set the throttle lever to the
MAX-position. (
4.)
● Set driving direction selector lever to
rear position (reverse driving direction).
( 8.4)
● Disengage the parking brake, if
engaged. (
● By pressing the drive pedal, the driving
speed is regulated and the machine
moves backwards.
11.2)
8.2)
8.9)
11.2)
8.2)
8.9)

11.5 Braking

Risk of injury:
Before braking, reduce the driving
speed by easing the pressure on
the drive pedal:
If possible, refrain from braking
abruptly at the maximum driving
speed.
Before each use, check the braking
function.
● Reduce driving speed.
● Press the brake pedal down evenly until
the machine comes to a standstill.

11.6 Adjusting the cutting height

Risk of injury:
For safety reasons, the cutting
height should only be adjusted
when the machine is at a standstill.
● Brake the machine to a complete
standstill.
● Unlock and hold the cutting height
adjustment lever. ( 8.10)
● The cutting height can be adjusted by
moving the cutting height adjustment
lever upward or downward to 6 cutting
levels.
● Lock the cutting height adjustment
lever. ( 8.10)
Cutting level 1:
35 mm cutting height
Cutting level 6:
90 cm cutting height
0478 193 9901 A - EN