John Bean B340 Manual Do Operador página 100

26
26
100
5-65
26
5-66
5-67
5-68
5-69
Operation
Figure 5-65 MINIMISATION "Un.6"
— Rotate the wheel into marking position following the
arrows.
— In this position mark the tyre, on the outer side of
the wheel, precisely above the chuck.
— Confi rm by pressing the key 26.
The MINIMISATION "Un.7" screen is displayed (Fig.
5-66).
Figure 5-66 MINIMISATION "Un.7"
— On the tyre changer, turn the tyre with respect to
the rim until the valve is aligned with the mark made
on the tyre.
— Confi rm by pressing the key 26.
The MINIMISATION "Un.8" is displayed (Fig. 5-67).
Fig. 5-67 MINIMISATION "
— Clamp the wheel.
— Rotate the wheel until the valve is exactly
perpendicular to and above the chuck.
— Confi rm the valve position by pressing the key 26.
The MINIMISATION "Un.9" is displayed (Fig. 5-68).
Figure 5-68 MINIMISATION "Un.9"
START is displayed on the screen
— Perform the wheel measuring run.
A measuring run is performed.
The MINIMISATION screen "Un.10" is displayed,
outside (Fig. 5-69) or the MINIMISATION "Un.10"
appears, inside (Fig. 5-71).
With indication H0
Optimum condition has been achieved and cannot be
improved.
— Continue as shown on screen BALANCING
(Fig. 5-59).
8"
Un