John Bean B340 Manual Do Operador página 118

2e 2e 2e
3e 3e 3e
6e 6e 6e
118
1e 1e 1e
6-14 6-14 6-14
6-15 6-15 6-15
4e 4e 4e 5e 5e 5e
6-15b 6-15b 6-15b
6-16 6-16 6-16
Maintenance
6.8 Print and report management
The machine allows creating reports that can be sent
to the remote software or copied on a USB memory
device in .pdf format.
Once print or report exchange has been enabled (refer
to section 7.3 / Fig.7-10) the icon will appear inside the
balancing window (1e Fig. 6-14).
Press key MULTIMEDIA (1e Fig. 6-14) to shift to
MULTIMEDIA screen (Fig. 6-15).
Press key CUSTOMER DATA ENTRY (2e Fig. 6-15) to
open CUSTOMER DATA ENTRY screen (1 Fig. 6-16).
In CUSTOMER DATA ENTRY screen (Fig. 6-16),
you can enter all the data relating to customer, wheel
position, vehicle, position, etc.
Once customer data have been entered, press key
SAVE AND QUIT(11e Fig. 6-16) to save data, quit
and go back to the previous screen (Fig. 6-15).
Press key ADD BEFORE BALANCING (3e Fig.
6-15b) to add to the report the measurement run
data, i.e. the one carried out before the application of
balance weights, by overwriting any existing value.
Press key ADD AFTER BALANCING (4e Fig. 6-15b)
to add to the report the check run data, i.e. the one
carried out after the application of balance weights,
by overwriting any existing value.
Press key SEND REPORT (5e Fig. 6-15b) to send
the report to the remote software, if enabled.
Press key PRINT (6e Fig. 6-15b) to send the report
in .pdf format to the USB memory device.
11e 11e 11e