Babyauto MORE LENNOX 01 Manual De Instalación página 20

3. CAR SEAT PARTS USAGE
3.1. Usage of buckle
1. Open the harness buckle by pressing the red
button on the buckle and put the the harness on
both sides of the seat.(fig. 3.1.1).
2. Put together the 2 parts of the fastener.
3. Connect the 2 parts of the fastener, inserting
them into the buckle until you hear a click (fig.
3.1.2∫) which indicates that it is securely locked.
3.2.Usage of harness
Loosen the harness
1. To loose the harness straps Strech the chest
section while holding down the harness
adjustment button
to pull only by the harness straps not by the
shoulder pads straps.
Tighten the harness
1. Pull the harness upwards to remove the slack
from the harness straps
2. Pull the harness adjustment strap
harness is fully tighten. The harness should be
20
(E) (fig. 3.2.1). Make sure
(G) until the
adjusted as tightly as possible without causing
discomfort to the child (fig. 3.2.2).
3. Remember that in order to guarantee the child's
safety, harness must be well-tightened .
3.3. Headrest
regulation
The correct adjustment of the headrest ensures
that the child is properly fastened into the car seat.
The headrest must be adjusted so that the harness
(which moves with the headrest) is at shoulder
height on the child or slightly above, but never
behind the back or at ear level (fig. 3.3.4).
1. Find the headrest height regulator
the back side of the seat (fig. 3.3.1).
2. After loosening the harness, by pulling the
regulator outwards move it up or down to
shoulder height in accordance with the size of the
child. (fig. 3.3.2 y 3.3.3). The height of shoulder
strap will also adjusted simultaneously with the
headrest.
3. Check that the selected heigth is right with the
child's height. If not, readjust the headrest.
and harness height
(O) located in