Babyauto MORE LENNOX 01 Manual De Instalación página 22

4. CAR SEAT INSTALLATION
1. Clip the insertion guides
anchorage points in the vehicle (fig. 4.1).
2. Take completely out the Isofix arms
pressing the button
and pulling out the arms (fig. 4.2).
3. Place the child seat on the car seat. Make sure the
support leg is in the right angle and rests firmly on
the floor of the vehicle (see chap. 3.4)
4. Guide the Isofix system connectors on the child
seat into the insertion guides until they lock
into the Isofix anchorage points in the vehicle
and there is an audible "click". The Isofix system
indicator will change from red to green when the
child seat is securely locked in place (fig. 4.4)
5. Push the child seat against the car seat to check
that the Isofix system is fully latched, ensuring the
child seat is as close to the car seat as possible.
6. Shake the child seat to check is firmly anchored.
4.1 Uninstalling the Isofix connectors
1. To release the isofix connectors, push the button
(L)
on the anchors to unlock them. This will
22
(Q)
onto the Isofix
(M)
(L) in both sides of the seat
release the child seat. The green indicator will turn
red showing the Isofix arms are opened (fig. 4.5).
5. FASTENIG THE CHILD TO THE SEAT.
by
GROUP 0+/1
Only Group 0+/1. From 0 to 4 years
approximately. (0-18 Kg)
1. Open the harness and place the child on the seat
Follow the steps described in chapter 3.1.
2. Adjust the headrest and harness height in
accordance to the child's height. See chapter 3.3.
3. Lock the harness buckle and make sure the harness is
tighten and fits child's body. See chapter 3.2.
IMPORTANT: DO NOT PLACE the child seat in fig.
5.1 described position when the car is moving. You
should turn it to the driving status (group 0+ or
group 1) after fastening the child to the seat.
IMPORTANT: DO NOT USE forward facing installation
before the child's weight exceeds 9 kg.