SETUP
Battery Installation
Open the Belt Clip and swing away from
unit back.
With a flat blade screwdriver, remove the
retaining screw from the Battery Cover.
With thumb, press down on battery
cover and toward unit bottom to expose
battery cavity.
Install Batteries as illustrated inside unit.
Replace cover in reverse order. Install
retaining screw. Snap the belt clip into
position.
Lead Wire Installation
Position lead wire connector over unit
connector and push down until seated.
NOTE:
Refer to the VitalStim Electrode
Instruction Card contained within
the electrode packet for electrode
preparation and lead wire attachment to
RETAINING
SCREW
electrodes.
Attach Lead Wire Clip to Patient. Make
certain there is enough slack in the lead
wire to allow head movement.
7
VitalStim™ Therapy Unit