Device Setup; Scope Of Delivery, Device Connection, Performance Check - DJO ARTROMOT-S4 Modo De Empleo

4. Device setup

Note: For a better understanding of each
step, please fold out pages II and III.
4.1 Scope of delivery, device
connection, performance
check
The equipment supplied includes these
items:
Seat, programming unit (1), patient chip
card (2), power cord, system rack (35),
motion element (32), forearm support (20),
armrest for healthy arm (4), element for
height adjustment of armrest (5), operating
instructions
1. Mount the system rack onto the chair by
inserting it in the holder on the back un-
til only the OK label is visible. Secure the
rack by tightening the thumbscrew (45).
2. Fasten the motion element (32) on the
width adjustment/lateral adjustment
unit (34) of the system rack. Fix it by ful-
ly tightening the thumbscrew (33). Check
that the red mark points to the recess.
3. Connect the motor control cable (39) to
one of the corresponding sockets (40 or
41) and screw it tight.
4. Connect the programming unit (1) to one
of the corresponding sockets (40 or 41)
and by plugging the cable in and screw-
ing it tight.
5. Connect the backrest (30) to the crank
handle for adjusting the depth of the
backrest (10) by introducing the end of
the crank handle into the guide rail in the
backrest (36).
6. Connect the power cord to socket (42) of
the device and connect the power plug
to a wall outlet with a non-fused earthed
wire (100 to 240 Volt, 50/60 Hz).
7. Turn the power switch (43) on.
8. The display of the programming unit
prompts you to indicate whether the mo-
tion element is mounted on the right or
on the left. Indicate the appropriate side:
the motion element will automatical-
ly move to the position in which the fore-
arm support can be mounted.
9. Secure the forearm support by inserting
the receiving tube for length adjustment
(22) into the guide and fastening it with
the clamping lever for length adjustment
of the forearm support (26).
10. Press the START button: the device auto-
matically moves to the starting position
(similar to "New Patient" function).
11. Finally, mount the armrest for the healthy
arm on the motion element on the oppo-
site side. For this, open the thumbscrew
for width adjustment (6) and insert the
fastening element of the height adjust-
ment unit, then tighten the thumbscrew
again. Open the clamping lever for height
adjustment of the armrest (5) and insert
the armrest (4), then close the clamping
lever again.
Caution!
m
Personal injury –
Only the supplied control pendant and
the motion element may be connected to
sockets (40) and (41). It is not permitted
to connect any other devices to these
sockets.
78