Device Setup; Connecting The Artromot®-E2/-E2 Compact, Performance Check - DJO ARTROMOT-E2 Instrucciones De Uso

4. Device setup

Note: See device description on pages
IV/V and IX/X.
4.1 Connecting the
ARTROMOT®-E2/-E2 compact,
performance check
The equipment supplied includes these
items:
Base unit (chair), motion element, pro-
gramming unit (15), patient chip card (17),
arm rest (4), power cord (not shown),
operating instructions
1. Set up the device and connect the
required cables by reversing the
transport instructions given in sec-
tion 6.3.
2. Follow these steps to set the carriage
to the home position:
Initial adjustment for new
patients
Write the patient's name down on the
back of the chip card. Insert the original
patient chip card (17) into the program-
ming unit (15).
Press the MENU key on the programming
unit seven times in rapid succession or
give it one long press to access program-
ming level seven (with each key press, you
advance one level).
Press the "new patient" parameter key
and select this function (a check
mark appears in the circle next to the
function).
Press the START key. The CPM device
automatically enters the home position.
Adjustment with
programmed chip card
Insert the original patient chip card (17)
into the programming unit (15).
Press the START key.
The CPM device automatically moves to
the starting position (middle position of
the set extension/flexion and pronation/
supination values).
Performance check
If the programming unit can be operated
as described above and the ARTROMOT®-E2/
-E2 compact moves to the home position
(for home position values, please refer to
sections 5.3), the CPM device has passed
the performance check.
The device also runs performance checks
regularly during operation. This is what
happens, if a problem is identified:
− An audio signal sounds.
− The device switches off immediately.
− The message "ERROR" and an error code
(e.g. ERROR 5) appear on the display.
In this situation, you may attempt to
restart the device by turning it briefly
off and on again with the power switch.
If the error message persists, have the
device inspected by a Service technician,
before using it again.
If it has been determined that the
ARTROMOT®-E2/-E2 compact operates
perfectly, ask the patient to sit down on
the ARTROMOT®-E2/-E2 compact chair.
59