Settings - Festool ISC 240 Li Manual De Instrucciones Original

Insulating material
PUR/PIR
< 36 kg/m³
Polystyrene
< 45 kg/m³
7

Settings

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Hot and sharp tools
Risk of injury
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves.
WARNING
Sharp saw blades
Risk of injury
► Attach the protective cover to the cutting
set when performing any work on the pow­
er tool.
7.1 Fitting a cutting set [3]
WARNING
Sharp, incorrectly inserted saw blades
Risk of injury
► Never insert individual saw blades into the
power tool.
► Only use saw blades in conjunction with a
cutting set.
► Always combine saw blades with the asso­
ciated guide rail.
► If necessary, push the extractor connec­
tor [3-1] upwards.
► Release the rotary knob.
► Open the cover flap.
►
Saw blade
►
►
►
The retaining pins [3-5] in the guide rail holder
are seated fully in the recesses in the guide rail.
►
►
7.2
► If necessary, push the extractor connec­
►
►
►
The clamping sleeve is unlocked.
►
►
7.3
blade, the adjusting levers [5-1] are worn. The
cutting set must be replaced.
Adjust the cutting sets with serrated saw blade
before initial operation. The movable saw blade
must be positioned above the fixed saw blade.
►
►
►
The movable saw blade is positioned above the
fixed saw blade.
►
► Carry out the same steps for the upper ad­
Turn the lever on the clamping
sleeve [3-2] anti-clockwise to unlock the
clamping sleeve.
Pull the movable saw blade on the sin­
gle-cam shaft (T shaft) [3-4] along the
guide rail [3-3] as far as it will go to remove
it.
Push the movable saw blade into the
clamping sleeve as far as it will go.
Turn the cutting set clockwise by ap­
proximately 30° until the guide rail is level.
Close the cover flap.
Close the rotary knob.
Removing the cutting set [4]
tor [3-1] upwards.
Release the rotary knob.
Open the cover flap.
Turn the lever on the clamping
sleeve [4-1] anti-clockwise.
Turn the cutting set anti-clockwise by
approximately 30°.
Remove the saw blade from the clamp­
ing sleeve.
Adjusting the cutting set with serrated
saw blade [5]
If the fixed saw blade can no longer be
positioned underneath the movable saw
Move the protective cover until the lower
adjusting lever [5-1] is free.
Turn the adjusting lever until both saw
blades are level and parallel with one an­
other.
Turn the adjusting lever clockwise by
one latching point.
Push the protective cover back.
justing lever.
English
17