Storing The Appliance; Maintaining The Appliance - Dirt Devil AQUAclean Manual De Instrucciones

steam button to produce steam boosts (fig.
After cleaning, place the On/Off button in 'Off' po-
6
). ➔ The steam cleaner cools down,
sition (fig. /
2
7
the steam ready indicator goes out.
out of the mains socket.
ter steam cleaner has cooled down.
Using appliance as hand-held steam cleaner
Activate the quick release of the hand-held steam
1
cleaner (fig. / ) and lift the appliance body from
1
5
the telescopic tube (fig.
tube with the steam base against the wall.
Install the desired accessory > "Using the acces-
3
sories" auf Seite 23. When using the 360° adapt-
4
er, turn the 360° adapter clockwise onto the hand-
held steam cleaner until you hear it click in place (fig.
). Clean the desired areas, see > "Cleaning hard
16
5
floors" auf Seite 22. Press the steam button to pro-
6
duce steam boosts (fig.
place the On/Off button in 'Off' position
). ➔ The steam cleaner cools down, the
(fig. /
2
7
steam ready indicator goes out.
of the mains socket. Remove the accessory after
9
steam cleaner has cooled down.
Using the accessories
Using 360° adapter with jet nozzle or soft brush
Firmly press the jet nozzle or soft brush togeth-
1
er on the 360° adapter until you hear it click in place
(fig. ). To change the angle of the attachment,
15
2
pull the rotating collar forward and turn the attach-
ment in the desired direction (fig.
remove the attachment, activate the release tab.
To remove the 360° adapter, push the release but-
4
ton forward and turn the 360° adapter counter-clock-
wise (fig. ).
16
Using spot jet nozzle
Assemble the spot jet nozzle without 360° adapt-
1
er directly on the hand-held steam cleaner or on the
telescopic tube (fig. ).
15

Storing the appliance

CAUTION!
Never store the steam cleaner with microfibre
pad attached. Store it on a moisture-proof sur-
face.
Place the steam cleaner in the wall mount
1
(fig. ). Pull plug from the mains socket and wind
7
2
cord around the quick cord release hooks (fig.
1 /
10
Pull the plug
7
Remove the accessory af-
8
). Lean the telescopic
17
2
/ ). After cleaning,
1
10 7
Pull the plug out
8
/ – ).
18
1 4 3
1
EN

Maintaining the appliance

).
Emptying the dual tank
!
WARNING!
Hot surface! Only empty the dual tank when the
steam cleaner is cooled down.
Remove the dual tank, > "Removing the dual tank"
1
auf Seite 21.
2
Rinse detergent tank with water and close both
3
tanks again.
4
Washing microfibre and textile pad
CAUTION!
Do not use bleach or fabric softener when wash-
ing the microfibre or textile pad.
Wash microfibre pad in the washing machine
1
(max. 40 °C) or hand-wash textile pad.
washed pad to dry completely for at least 24 hours.
Cleaning compact brush
Activate the release for the telescopic tube and re-
1
move telescopic tube with appliance body.
the compact brush from the glider.
pact brush under running water (max. 40 °C).
Allow the washed brush to dry completely for at
4
least 24 hours.
To
Replacing water filter
CAUTION!
Use steam cleaner only with water filter. Depend-
ing on water hardness and frequency of use, the
filter must be replaced every 3 to 6 months.
Remove the dual tank, > "Removing the dual
1
tank" auf Seite 21.
front (fig. ).
10
3
ing it into the opening.
/ ).
12
Empty any excess water into a sink.
Reinsert dual tank in steam cleaner.
2
Wash the com-
3
Pull water filter off towards the
2
Insert the new water filter by push-
Reinsert the dual tank.
4
23
Allow the
Pull
2