Scope Of Delivery; Instructions For Use - Ottobock Lamination Anchors Instrucciones De Uso

► Do not expose the product to unallowable environmental condi­
tions.
► If the product has been exposed to unallowable environmental
conditions, check it for damage.
► If damage is apparent or in case of doubt, do not continue using
the product.
► Take suitable measures if required (e.g. cleaning, repair,
replacement, inspection by the manufacturer or a specialist
workshop etc.).
CAUTION
Exceeding the service life
Risk of injury due to change in or loss of functionality and damage to
the product
► Ensure that the approved service life is not exceeded.
CAUTION
Mechanical damage to the product
Risk of injury due to change in or loss of functionality
► Use caution when working with the product.
► If the product is damaged, check it for proper function and readi­
ness for use.
► In case of changes in or loss of functionality, do not continue
using the product (see "Signs of changes in or loss of functional­
ity during use" in this section).
► Take any necessary measures (e.g. repair, replacement, inspec­
tion by the manufacturer's customer service, etc.).
Signs of changes in or loss of functionality during use
Among other factors, changes in functionality can be indicated by an
altered gait pattern, a change in the positioning of the prosthetic com­
ponents relative to each other and by the development of noises.

4 Scope of delivery

Lamination anchor, 3-arm
Quant­ Designation
ity
1

Instructions for use

1 Lamination anchor
For 4R41, 4R89: Cap screw (steel)
1
For 4R42*: Lamination dummy
1
1 For 4R41: Screwed insert, pyramid
receiver
4 For 4R41: Set screw
For 4R89: Screwed insert, pyramid
1
adapter
Lamination anchor, 4-arm
Quant­ Designation
ity
1 Instructions for use
1 Lamination anchor
1 Cap screw (steel)
1 Rounded washer
1 Screwed insert, pyramid receiver
For 4R111, 4R119:
For 4R119=T:
4 Set screw
For 4R111, 4R119, 4R119=T,
4WR95=1:
1 Screwed insert, pyramid adapter
For 4R116, 4R117:
For 4R116=T, 4R117=T:
Reference num­
ber
–
–
501Z2=M5x30
4X3
4R44=N
506G3=M8x12-V
4R87
Reference num­
ber
–
–
501Z2=M5x30
507U16=5.2-NIR­
O
4R44=N
4R44=T
506G3=M8x12-V
4R87
4R87=T
15