Scope Of Delivery; Preparation For Use - Ottobock 9X18 Instrucciones De Uso

6 Delivery

6.1 Scope of Delivery

1 pc. 9X18 Cable Pull Switch
2 pcs. 501S46=M3x5 Oval head screw
2 pcs. 501S46=M3x8 Oval head screw
1 pc. 647G401 Instructions for Use

7 Preparation for Use

7.1 Connecting the Electrode Cable
The cable pull switch is delivered without connecting cable. It must be
ordered separately. Appropriate cables are 13E50=*, 13E97=*, 13E98=1200
and 13E99=1200 connecting cables. Abundantly apply 633F11 Silicone
Grease before connecting the contacts of the connecting cable. The grease
will protect the connectors from sweat and humidity.
7.2 Mounting the Pull-Cable to the Stirrup
The cable pull switch is delivered with pre-assembled pull-cable. When
mounting the cable pull switch to a provisional or definitive socket you must
connect the free end of the pull-cable to the stirrup.
The pull-cable of the cable pull switch can also be fed through a cable hous­
ing to the shoulder harness. When positioning the cable housing, make sure
there are no tight angles, edges or kinks and that the cable runs smoothly.
1) Determine the necessary cable length, but do not yet shorten the cable.
2) Form the pull-cable into a loop and feed it into the stirrup (Fig. 1).
3) Place the wedge into the stirrup and tighten the pull-cable (Fig. 2).
Then check the length of the cable and adjust if necessary. You must first
remove the wedge before doing this. After the correct cable length is set,
cut the pull-cable to length.
8 Disposal
This product must not be disposed of with regular domestic waste.
Disposal that is not in accordance with the regulations of your country
may have a detrimental impact on health and the environment. Please
observe the information provided by the responsible authorities in
your country regarding return and collection processes.
10 | Ottobock