Hofmann geodyna 8250 Manual De Operador página 22

1 2
5
9
10
12
22
6
3
4
7
8
11
12b
13
4-6
Layout
Fig. 4-6 RIM DATA ENTRY
Rim data entry Screen.
Open using the Manual Data Entry key (3, Fig. 4-5).
Specifi c commands:
1 - HELP key - Selects HELP texts.
2 - HOME key - Returns you to the starting page
(INTRO SCREEN).
3 - SPECIAL key -
Opens the WHEEL PROFILES screen page, for saving
or selecting wheels with pre-set dimensions (
4 - ESC key -
- Returns you to RIM DATA ENTRY
5 - DISTANCE key - (OFFSET) - To change the value
press one of the arrows.
- The right arrow increases the value.
- The left arrow reduces the value.
6 - WIDTH key - For changing the rim nominal width
value set.
- The right arrow increases the value.
- The left arrow reduces the value.
Note: Rim width is displayed in 0.10" steps.
7 - DIAMETER keys - For changing the rim nominal
diameter value set.
- The upper arrow increases the value.
- The lower arrow reduces the value.
8 - START key - Starts the measuring run.
9 - "INCH / MM" key - For selecting alternatively
inches or millimetres, press directly on one of the
measurements shown.
10 - "G / OZ" key - For selecting readings in grams
or ounces.
11 - "ALU" keys - For directly selecting the positions
for application of weights on the rim.
12 - "TOGGLE" key - For activating the "Easy Alu
Toggle" ( 5.8.2) option. After a fi rst selection the
F
key is no longer active and appears greyed out (12b).
13 - For manually entering wheel dimension
information.
5.8.3).
F