Nussbaum BM 11 Instrucciones De Uso página 62

Is the PAX balancing program active (LED 19 PAX is light)
the value is displayed in mm.
Press + Button.
Anzeige:
Wheel guard OPEN
or
Wheel guard CLOSED.
The display will change when the wheel guard is open-
ed or closed.
Press + Button.
Brake active
or
Brake not active
The display changes when the brake is activated or de-
activated via the ALU button.
Press + Button.
QuickSpan switch OPEN
or
QuickSpan switch CLOSED
The display changes when the QuickSpan switch is acti-
vated or deactivated via the foot pedal.
Press + Button.
Actual temperature in 1/10 °C
No temperature sensor has been recognized
during power up of the machine.
62
The temperature is measured in a range of 200 to 700
(corresponds to -20°C to +70°C).
Temperature < -20° C, Outside measuring range
Temperature > 70° C, Outside measuring range
Press + Button.
Actual temperature in 1/10 °C at which the
machine was calibrated.
The machine has not yet been calibrated with
a temperature sensor in place.
F10: Calibration of the gauges
(As of software version 1.4)
This function enables the inside gauge and if  tted the
outside gauge to be calibrated. This is necessary if in-
correct measurement data for the clamped wheel is
displayed after using one or both of the gauges. Ac-
curate balance results rely on the correct wheel data
being inputted.
!
It is important that the gauges are always placed in
the home position after measurements as this can
result in inaccurate results.
!
The brake should be released on all machines that
have this function.
Routine:
Remove the clamp and cone from the main shaft and
screw the calibration weight into its threaded recess on
the outside of the adapter as shown:
Press ENTER key (12) to select the function menu. Use +/-
key (4/5), (6/7) or (8/9) to select the Function 10.
03.07.2013 1 689 979 917N