Fitting And Removing The Skirt - Stihl FSA 130 Manual De Instrucciones

English
► Insert the wingscrew (1).
► Swing the handlebar (3) up.
► Tighten down the wingscrew (1).
► Take out the screw (6).
► Position the control handle (7) on the handle‐
bar (3), trigger facing the gearhead, and line
up the hole in the control handle with the hole
in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6).
The loop handle (2) need not be removed again.
6.2 Mounting and Removing the
Deflector
6.2.1 Mounting the Deflector
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
2
► Push the deflector (1) into the guides on the
gear housing as far as stop.
► Insert and tighten down the screws (2) firmly.
6.2.2 Removing the Deflector
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
2
► Take out the screws (2).
► Pull off the deflector (1).
6.3

Fitting and Removing the Skirt

6.3.1 Fitting the Skirt
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
32
1
1
1
2
► Slide the guide slot in the skirt (2) onto the
deflector (1) – it must snap into position.
► Push the line limiting blade (3) into the slot in
the skirt (2).
► Insert and tighten down the screw (4) firmly.
6.3.2 Removing the Skirt
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Insert stop pin (2) into the hole in the skirt (1).
► Use the stop pin (2) to slide the skirt (1) off the
deflector.
The line limiting blade (1) can be left on the skirt.
6.4 Mounting and Removing the
Mowing Head
6.4.1 Mounting the Mowing Head
► Switch off the trimmer and pull the connecting
cable plug out of the socket.
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise.
► Insert the stop pin (4) in the bore as far as
stop and hold it depressed.
6 Assembling the Trimmer
3
4
2
1
1
2
3
4
4
0458-726-9821-D
1