Care; Troubleshooting; Washer Operation - Maytag EPIC z Manual De Uso Y Cuidado

Clean Washer
Use the Clean Washer cycle once a month to keep the inside of your washer fresh and clean.
This cycle uses a higher water level in combination with liquid chlorine bleach to thoroughly
clean the inside of your washing machine. See "Cleaning Your Washer" in the Washer Care
section.
IMPORTANT: Do not place garments or other items in the washer during the Clean Washer
cycle. Use this cycle with an empty wash drum.
As with any new product, you will hear sounds that you are not accustomed to. You may hear
various sounds when the door is locked or unlocked, and during the washing, rinsing, or
spinning process. Between changes in wash actions, there will be momentary pauses. You
will hear water spraying and splashing during the wash and rinse cycles. These new sounds
and pauses are part of normal washer operation. See "Troubleshooting."
You can customize your wash by adding options to your cycle selections. You can add or
change an option after starting a cycle anytime before the selected option begins. Not all
options are available with all cycles.
O @ PREWASH
O @ MAX EXTRACT
O _ STAIN CYC£E
O EXTRA RINSE
• See the "laundry Guide" section for an overview of possible options for each Wash Cycle
selection.
• If an option is available with a selected cycle, the light for that option will illuminate
when selected.
• If an option is unavailable with a selected cycle, there will be a short tone and the light for
that option will not illuminate when selected.
Prewash
Use this option for loads of heavily soiled items that need pretreatment.
• Add detergent to Main Wash compartment of the dispenser drawer.
]his option adds tumbling time prior to the selected main cycle. The washer continues
automatically from prewash into the main wash cycle.
Stain
Cycle
Use this option for heavily soiled loads that need improved stain treatment. When Stain Cycle
is selected, the water temperature of the selected wash cycle is automatically set to warm. The
water will then be heated to a hot water temperature to aid in stain removal. ]his option will
provide optimal removal of organic stains such as blood.
Extra Rinse
An extra rinse can be used to aid in the removal of detergent or bleach residue from garments.
This option provides an additional rinse with the same water temperature as the Normal rinse.
Cycle Signal
This signal is helpful when you are removing items from the washer as soon as it stops, Select
ON or OFF.
Preset cycle settings of Wash/Rinse Temperature and Spin Speed can be changed. You can
change a modifier after starting a cycle anytime before the selected Modifier begins. Not all
modifiers are available with all options and cycles.
i I EX HOT/COLD
HIGH i HOT/COLD
l MEDIUM ii WARM/WARM
_i_ LOW _iiii W ARM/COLD
i_NO SPIN ii COLD/COLD
Q 0
SPIN WASH/RINSE
SPEED TEMP
ALLAUTO TEMP
CONTROL
lb change the spin speed, select the SPIN SPEED button until the desired setting
illuminates.
lo change the water temperature, select the WASH/RINSE TEMP button until the desired
setting illuminates.