Problem And Troubleshooting - Maytag EPIC z Manual De Uso Y Cuidado

TROUBLESHOOTING
First try the solutions suggested here to possibly avoid the cost of a service call...
Error codes
An error code may be shown in the Estimated Time Remaining display. Check the list below
for potential problem and troubleshooting checks.
• "F20" on display (Water Inlet Problem--no water or insufficient water supply)
Select PAUSE/CANCEI_ twice to cancel the cycle. Unplug washer or disconnect power.
Check the following:
Are water faucets completely turned on?
Are screens at inlet hose connection to washer clogged? Are water inlet hoses kinked?
Are water inlet hoses frozen?
• "SD" (Suds Routine)
When excessive suds are detected, a suds routine automatically starts. [his routine
removes extra suds and assures proper rinsing of your garments. "SD" is displayed during
rinsing and at the end of the cycle to inform you that the Suds Routine was activated. Use
only HE (High Efficiency) detergents.
• "F" Variables [F01 - F34] (Electrical Problem)
Select PAUSE/CANCEk twice to cancel the cycle. Select RINSE & SPIN, and then select
EXTRA RINSE (to turn off the rinse option) if there is excessive water in the washer.
Re-select cycle and press STAR[: [f the problem remains, call for service.
Noisy, vibrating, off-balance
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire_ or electrical shock.
Plug in washer or reconnect power. Re-select cycle and press START. If the problem
remains, call for service.
"F21" on display (Drain Problem)
Select PAUSE/CANCEl twice to cancel the cycle. Unplug washer or disconnect power.
Check the following:
is the drain hose kinked?
Is the washer level?
[he washer must be level. The four feet should be properly installed, and the nuts should
be tightened against the washer cabinet.
All four feet of the washer must be in firm contact with the floor. If the washer is on a
pedestal, the washer must be secured to the pedestal and all four pedestal feet must be in
firm contact with the floor.
• Washer making a different noise?
As with any new product, you will hear sounds that you are not accustomed to. You may
hear various sounds when the door is locked or unlocked, and during the washing,
rinsing, or spinning process. Between changes in wash actions, there will be momentary
pauses. You will hear water spraying and splashing during the wash and rinse cycles.
These new sounds and pauses are part of normal washer operation.
• Is washer installed on a sturdy and solid floor?
Refer to the "Installation Instructions" for flooring requirements. Noise and vibration may
be reduced by placing a piece of _/2' (19.1 ram) plywood underneath your washer. The
plywood may extend underneath both washer and dryer to keep them at equal heights.
• Is the washer gurgling or humming?
As water is drained from the washer, you may hear air being pulled through the pump.
This happens during the end of draining. [t is normal.
• Are you washing items with metal snaps, buckles or zippers?
You may hear metal items touching the washer drum. This is normal.
• Were the 4 shipping bolts in the back of the machine removed?
See "Remove Transport System."
Is the drain hose frozen?
Is the drain hose clogged?
Is the drain hose more than 96" (2.4 m) above the floor?