Electrical Shock Hazard - Maytag EPIC z Manual De Uso Y Cuidado

_J_c¸'_ _IS(_ ¸ I9_8I__ ° _¸¸¸/_' _"_
1. Drape the power cord over the washer top.
2. Move the washer to its final location.
3. Place the drain hose in the laundry tub or standpipe as shown. See illustrations A and B.
1. Check the electrical requirements, Be sure that you have the correct electrical supply and
the recommended grounding method. See "Electrical Requirements."
2. Check that all parts are now installed. [f there is an extra part, go back through the steps to
see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
4. If the washer faucets and the drain standpipe are recessed, put the hooked end of the
drain hose in the standpipe as shown. See illustration C.
NOTES:
• Do not force excess drain hose back into the rear of the washer.
• [b avoid siphoning, do not seal the drain hose into the standpipe.
I _=I =i iI r/ I +_, I 1,1++,I= I _>,=
Properly leveling your washer avoids excessive noise and vibration.
1. Check the levelness of the washer by placing a level on the top edge of the washer, first
side to side, then front to back.
If the washer is against a wail, move the washer out slightly before tipping back. [f the
washer is not level, first prop the front with a wood block and adjust the feet as necessary;
then prop the back and adjust feet as necessary. Repeat this step until washer is level.
2. Make sure all four feet are stable and resting on the floor. Then check that the appliance is
perfectly level (use a level).
3. After the washer is level, use a 14 mm open-end wrench to turn the nuts on the feet tightly
against the washer cabinet.
IMPORIANT: All four feet must be tightened. If the nuts are not tight against the washer
cabinet, the washer may vibrate,
4. The washer should not move front to back, side to side, or diagonally when pushed on its
top edges.
5. Slide the washer to its final location.
6. Confirm the levelness of the washer.
7_
8.
9.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug into a grounded 3 prong outlet.
Read "Washer Use."
[b test and to clean your washer, measure V2 the detergent manufacturer's recommended
amount of HE High Efficiency detergent for a medium-size load. Pour the detergent into
the detergent dispenser. Select NORMAl, and then select START. Allow the washer to
complete one whole cycle.
Use only HE High Efficiency detergm_t.
12