Maytag EPIC z Manual De Uso Y Cuidado página 28

Load too wet
• Did you use the right cycle for the load being washed?
Select a cycle with a higher spin speed.
• Did you wash a single item or bulky items or have you overloaded the washer?
A single item, bulky items, or overloading may cause imbalance. Add items or try to
evenly distribute your wet laundry in the drum. Select RINSE & SPIN, and then select
EXTRA RINSE (to turn off the rinse option), to drain the washer. If the laundry is still wet,
take half of the load out of the washer and try again.
• Did you use HE detergent?
Suds during rinse and spin cycles can reduce spin speed. Use HE detergent.
Residue, lint, stains on load; gray whites, dingy colors
• Did you add detergent to the dispenser?
For best results, add detergent to the detergent compartment. Do not add detergent to the
washer drum.
• Did you sort properly?
Sort lint givers (towels, chenille) from lint takers (corduroy, synthetics). [-he transfer of dye
can occur when mixing whites and colors in a load. Sort dark clothes from whites and
lights.
• Did you overload the washer?
Do not overload the washer. The washer can be fully loaded, but not tightly packed. The
wash load must be balanced, lint can be trapped in the load if overloaded.
• Check the following:
Was paper or tissue left in pockets?
• Did you use enough HE detergent?
Follow manufacturer's recommendations for the type of load you are washing. For best
performance, use only High Efficiency detergent. Use enough detergent to remove soil and
hold it in suspension.
• Do you have hard water?
Use more detergent for washing heavy soils in cold or hard water.
• Is your water colder than 60°F (15.6°C)?
Wash water colder than 60°F (15.6°C) may not completely dissolve the detergent. Use hot
or warm washes if safe for the fabric load. Make sure your hot water system is adequate to
provide a hot water wash.
• Are you using a low speed wash cycle?
Powdered detergents may not dissolve well in a slow-speed cycle. For best results, use
liquid detergent for slow-speed cycles such as Delicates.
• Did you unload the washer promptly?
1i9 avoid the transfer of (lye, unload tile washer as soon as it stops.
• Did you use a fabric softener dispensing ball?
Dispensing balls will not operate correctly with this washer. Add liquid fabric softener to
the fabric softener compartment.
• Did you use powdered detergent in a low-speed cycle?
Consider using liquid detergent.
• Did you use Rapid Wash on a large load?
For best results, use Rapid Wash for small, lightly soiled loads.
Load is wrinkled, twisted, tangled
• Did you unload the washer promptly?
Unload the washer as soon as it stops.
• Did you use the right cycle for the load being washed?
Use the De[icates cycle or another cycle with a low spin speed to reduce wrinkling.
• Did you overload the washer?
The wash load must be balanced and not overloaded. Loads should tumble freely during
washing.
• Was the wash water warm enough to relax wrinkles?
[f safe for load, use warm or hot wash water.
• Are the hot and cold water hoses reversed?
Check that the hot and cold water hoses are connected to the right faucets. A hot rinse
followed by spin will cause wrinkling. See "Connect the Inlet Hoses."
2 8