Fine Adjustment For Each Input Signal; Blanking Adjustment - Sony VPH-G90E Manual De Instalación

Fine Adjustment for Each Input Signal

Blanking Adjustment

124
(GB) Adjustments
3
Adjust the shift with the arrow keys.
V : The picture is shifted upward.
v : The picture is shifted downward.
b :The picture is shifted rightward.
B :The picture is shifted leftward.
R G B S H I F T A D J
C O A R S E V S H I F T :
N A R R O W
H c : [ 5 0 ]
H f : 5 0
V : M I N
To adjust precisely, press the RGB SHIFT key again. The projector
enters the FINE adjustment mode, and you can fine adjust the
horizontal shift only.
By pressing the RGB SHIFT key again, the COARSE adjustment
mode is resumed.
4
Press the MEMORY key to save the adjustment data.
If the displayed picture is larger than the screen, cut off the excess parts.
1
Press the BLKG key.
The external signal and the 17 × 17 HATCH pattern overlap.
You can also change to the external signal only by pressing the
PATTERN key.
2
Press the POSITION +/– keys or the BLKG key to select the part to be
adjusted.
• When you press the + key or the BLKG key, the position cycles
through the following order:
TOP n BOTTOM n LEFT n RIGHT n TOP...
• When you press the – key, the position cycles in reverse order.
B L K G A D J
T O P
T : [ 5 0 ]
B : 5 0
ADJ:
L : M A X
NEXT:
R : 5 0
3
Adjust with the arrow keys.
• Press the V and v keys to adjust the TOP and BOTTOM positions.
• Press the B and b keys to adjust the LEFT and RIGHT positions.
Screen
Picture
ADJ:
+ –