Assembly - Dirt Devil AquaClean M318 Manual De Instrucciones

02_M318_gb.book Seite 36 Montag, 21. März 2011 1:15 13

2 Assembly

2.2 Assembly
2
3
4
36
1. Place the steam base on a flat surface.
2. Screw the pre-installed cross-head screw out of the
adapter on the steam base using a cross-head screw-
driver (Fig. 2).
3. Push the central console powerfully into the adapter on
the steam base as far as it will go.
NOTE:
The hole in the adapter must be visible through the hole
of the central console (Fig. 3). Otherwise, it will not be
possible for the screw to engage fully.
4. Screw the cross-head screw you just took out into the
hole provided (Fig. 4). Tighten the screw by hand.