Troubleshooting - Heiniger Saphir Basic C Instrucciones De Uso

7

Troubleshooting

y The here described tasks for troubleshooting can be done mostly by the
operator.
y Some tasks only may be done by especially trained personal or by an
authorised service centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts badly
or not at all
Motor is not running Battery is dead
Motor does not work Faulty motor and / or
Motor runs very
slowly
Running time of a
fully charged battery
is too short and / or
blades are getting
hot
The control light of
the charging station
in not on
Instruction manual / Small animal clipper
Cause
Clipperhead is not well
engaged
Turning lever is defective Replace turning lever (S)
Clipper blade is blunt
Clipper blades have not
been correctly ground
Clipper blades are not
oiled
The animal's hair is wet
Hairs jammed between
top and bottom blades
Clipperhead has too little
clipping pressure
Contacts dirty
Faulty battery
Smell of burning from
the motor housing. Motor
burned out.
electronics
Clipperhead blocked
Clipper blades were not
oiled sufficiently
Clipper blades were not
oiled sufficiently
Dead, not fully charged
or defective battery has
been used
Charging station is not
connected to the power
supply
Charging station is faulty Have charging station inspected
Rectification
Engage the clipperhead correctly
when the motor is running
Have top and bottom blades re-
sharpenend by service centre (S)
Oil clipper blades every 15
minutes
Only clip dry hair
Take off clipperhead, push the
top blade half away from the
clipperhead, take away hairs
between top and bottom blade.
Have clipperhead inspected (S)
Charge battery
Switch clipper off and clean the
contacts
Replace battery
Have motor and / or electronics
replaced (S)
Have motor and / or electronics
replaced (S)
Clean and oil clipperhead
Oil clipper blades
Oil clipper blades
Only use intact and completely
charged original battery
Connect the charging station to
the power supply
(S)
17