Troubleshooting; Safety Information; Causes Of Malfunctions And Their Rectification; Spare Parts - Heiniger Xperience Traducción Del Manual Original

NOTICE
Possible damage to the clipper!
Operating the clipper without the air filter can damage the clipper.
► Only use the clipper with a properly fitted air filter.

8 Troubleshooting

8.1 Safety information

DANGER
Mortal danger from electrical current!
Mortal danger can result from contact with current-carrying conductors or components!
► Pull the plug from the socket before you start troubleshooting.
► Repairs to electrical devices must only be carried out by the factory service
department or specialists who have been trained by the manufacturer.
During the warranty period the device must be opened only by personnal authorised by the
manufacturer, else the warranty will be void.

8.2 Causes of malfunctions and their rectification

Malfunction Possible cause
Upper blades moving Leaf springs have broken.
too little.
Square end of eccentric
shaft or eccentric shaft worn
(insufficient lubrication).
Upper blade does not Defective gear.
move.
Adjusting knob is Thread is dirty or rusty.
jammed.
Pressure spring is jammed.
Leaf springs in the Comb plate screws are loose.
head mount are too
loose.
Play between Leaf springs and/or cylinder
swivelling lever and head screws are worn.
leaf spring.
Swivelling lever is Centring sleeve lost.
difficult to move up
and down.
Motor does not run or Clipping pressure too strong.
stops immediately.
Burnt smell emanating from
the motor housing; motor
burnt.
Motor and/or electronics
defective.
34
All manuals and user guides at all-guides.com
Corrective measure
Notify customer service.
Notify customer service.
Notify customer service.
Tighten the comb plate screws.
Notify customer service.
Notify customer service.
Reduce the clipping pressure,
as described in chapter 7.2.
Have the blades sharpened.
Notify customer service.
Notify customer service.
Cattle clipper Xperience
Malfunction Possible cause
Motor runs very slowly. Clipping blades not lubricated
adequately.
Motor and/or electronics
defective.
Clipper is cutting Cutting blades are dull.
Clipping blades are not
poorly or not at all.
properly sharpened.
Clipping blades are not
lubricated.
Clipping pressure too low.
Leaf springs have broken.
The animal's hair is too wet.
Hairs are stuck between upper
and lower blade.
Clipping head has too much
play.
Clipping blades are not
properly aligned.
Motor unit heats up. Air filter clogged.
Clipping pressure too high.
Defective bearing.

9 Spare parts

See spare parts list at the end of these operating instructions.
CAUTION
Incorrect or defective spare parts can lead to damage, malfunction and complete
failure and can jeopardise safety.
► Use only original spare parts from the manufacturer. Obtain spare parts from an
authorised dealer or directly from the manufacturer.
NOTE
► If non-approved parts are used, all warranty, service, compensation and liability
claims against the manufacturer or its employees, dealers and representatives will be
forfeited.
During the warranty period the device must be opened only by personnal authorised by the
manufacturer, else the warranty will be void.
Cattle clipper Xperience
Corrective measure
Lubricate the clipping blades.
Notify customer service.
Notify customer service.
Lubricate the clipping blades
every 15 minutes.
Increase the clipping pressure
by turning the adjusting knob as
described in chapter 7.2.
Notify customer service.
Only clip dry hair.
Remove the clipping blades;
clean, lubricate and install them
again; set the clipping pressure.
Notify customer service.
Align the clipping blades
correctly, see Fig. 9.
Clean or replace the air filter.
Reduce the clipping pressure.
Notify customer service.
35