Changing The Clipper-Head - Heiniger Saphir Basic C Instrucciones De Uso

Fig. 18
Fig. 19

6.2.3 Changing the clipper-head

Fig. 20
Fig. 21
6. Fit the favoured clipperhead to the blade hinge and fold it on to the
switched-on clipper by light pressure. (fig. 15, 16, 17).
NOTE!
Only work with sharp blades, replace blunt or defective blades without teeth.
The correct resharpening of blades is only to do by special machines or by a
specialist. In that case, contact your service centre.
14
1. Move the switch to position "0" (fig.4).
2. Push the battery interlock (2) on both
sides inward and pull the battery (1)
out of the clipper.
3. Insert charged battery (1) into the
shearer (2), until the battery lock is
locked in on both sides.
1. Move the switch to position "0" (fig.4).
2. Push the interlock clipperhead.
3. Fold the clipperhead ahead when
the interlock clipperhead is pressed.
4. Take off the clipperhead.
5. Clean the opened hinge by the help
of the provided brush.
Instruction manual / Small animal clipper