Cleaning And Disinfection - Dräger X-plore 4000 Serie Instrucciones De Uso

4.2

Cleaning and disinfection

Clean and disinfect the half mask after each use.
WARNING
!
The mask body must be cleaned thoroughly so that there are
no residues of skin care products on the mask body. Otherwise
the elasticity in the sealing area could be reduced and the
mask will not fit anymore.
Failure to comply with this warning may result in poisoning or
death.
CAUTION
!
Danger of material damage!
Do not use solvents (e.g. acetone, alcohol) or cleaning agents
with abrasive particles for cleaning and disinfection. Use only
the described procedures and the specified cleaning agents
and disinfectants. Other agents, doses and exposure times
may cause damage to the product.
NOTICE
i
i
Silicone half masks are prone to absorb cleaning agents and
disinfectants. Therefore, skin irritation may occur if the
following procedure is not followed.
For
disinfectants and their specifications, see document 9100081
at www.draeger.com/IFU.
1. Remove the respiratory filter or powered air purifying respirator or
air line breathing apparatus from the half mask.
2. Prepare a cleaning solution of water and detergent.
3. Clean all parts with a soft cloth and a cleaning solution.
4. Thoroughly rinse all parts under running water.
X-plore 4000
information on suitable cleaning
Maintenance
products and
33