Oven Bottom - Sears Kenmore 3627325190 Manual De Uso

Broiler Pan and Rack
After broiling, remove the
broiler pan from the oven
or broiler compartment
(depending on your model)°
Remove the rack from the _ ......
pan. Carefully pour out I__, _
grease from the pan into a
proper container. Wash and ,
rinse the broiler pan and .................... :=__
rack in hot water with a
soap-filled or plastic scour-
ing pad.
If food has burned on, sprinkle the rack with deter-
gent while hot and cover with wet paper towels or a
dishcloth. Soaking the pan wilt remove burned
on foods.
Both the broiler pan and rack can also be cleaned in
the dishwasher
Do not store a soiled broiler pan and rack anywhere
in the range.
Do not clean the broiler pan or rack in the
self-cleaning oven.
Oven Shelves
Clean the shelves with an abrasive cleanser or steel
wool. After cleaning, rinse the shelves with clean
water and dry with a clean cloth..
NOTE: The oven shelves may be cleaned in the self-
cleaning oven.. However, they will darken, lose their
luster and become hard to slide° Wipe the shelf sup-
ports with cooking oil after self-cleaning to make
shelves slide more easily.
Oven Bottom
The oven bottom has a
To make cleaning easier,
protect the oven bottom
from excessive spi_lovers
by placing a cookie sheet -4<J
on the shelf below the
shelf you are cooking on.
You can use aluminum foil
if you do not cover the
whole shelf, This is partic-
ularly important when
baking a fruit pie or other foods with a high acid con-
tent. Hot fruit fillings or other foods that are highly
acidic (such as milk, tomatoes or sauerkraut and
sauces with vinegar or lemon juice) may cause pitting
and damage to the porcelain enamel surface and
should be wiped up immediately
To clean up spillovers, use soap and water, an abra-
sive cleaner or scouring pad. Rinse welt to remove
any soap before self-cleaning
Surface Light and Starter (on somemodels)
CAUTION: Do not touch
Canopy
the bulb with wet hands
or when bulb is hot.
Never wipe the light
Lift up
area with a wet cloth.
Electrical power must
be shut off if you have Starter
to replace a bulb.
To replace the bulb:
1. With one hand at each
end of the hinged Light bulb
canopy, grasp it by the
front edge and flip it up.
2. Remove the fluorescent light bulb Replace the bulb
with one of the same length and wattage°
3. Lower the canopy
To replace the starter:
1. Qpen the canopy and remove the bulb as explained
above,
2. Grasp the starter, turn it counterclockwise about
one-quarter turn and lift out, Replace with one of
the same wattage_
3. Replace the bulb and lower the canopy,
(continued next page)
29