Preparation; Installing The Plasma Display; Moving The Plasma Display - Pioneer PDP-507XG Manual De Instrucciones

Preparation

Chapter 5
Preparation

Installing the plasma display

Over
10 cm
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• Because the plasma display is heavy, be sure to have someone
help you when moving it.
Caution
• If you do not leave sufficient space above the plasma display, it
will not receive enough ventilation and will not operate
properly.
Note
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the unit.
Using the optional PIONEER stand
For details on installation, refer to the instruction manual supplied
with the stand.
Using the optional PIONEER speakers(for PDP-507XG
only)
For details on installation, refer to the instruction manual supplied
with the speaker.
Over 50 cm
Caution
Operating Environment
Operating environment temperature and humidity: +0 ºC to +40 ºC ;
less than 85 % RH (cooling vents not blocked). Do not install this unit
in a poorly ventilated area, or in locations exposed to high humidity or
direct sunlight (or strong artificial light).

Moving the plasma display

(For PDP-507XG)
Note
• Do not use the speaker to support the weight of the plasma
display.
• Always remove the speakers before moving the plasma display.
Do not hold the plasma display by the speaker mounting
fittings.
05
15
En