Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Additional information
Problem
• POWER ON indicator or STANDBY indicator
is quickly flashing.
If the following error codes appear on the screen, check the corresponding items in the table.
Code
Message
SD04 and SD11
Powering off. Internal temperature too high.
Check temperature around PDP.
SD05
PDP-507XG
Internal protection circuit turns power off.
Is there a short in the speaker cable?
PDP-427XG
Internal protection circuit turns power off.
Signal assignments for 15-pin D-sub connector
Pin No.
Signal assignment
1
R
2
G
3
B
4
Not connected
5
Not connected
6
GND (ground)
7
GND (ground)
8
GND (ground)
Standard channel allocation selections for countries and regions
Region
Taiwan
Hong Kong
Philippines
Thailand
Malaysia
Singapore
Indonesia
Saudi Arabia
Israel
Possible solution
• Internal protective circuits may have been activated. First turn the main power off by pressing POWER on the
plasma display, and then turn the power on again in after one minute or more.
• If the problem is not solved with this, contact a Pioneer Service Center or Pioneer Authorized Independent Service
company. These are listed on your warranty card for each country or region.
Standard channel allocation
Cable (US Type)
Normal
Cable (US Type)
Normal
Normal
Normal
Normal
Normal
Normal
Check
Check if the ambient temperature of the plasma display is high.
Check the speaker cable connections between the plasma display and
the speakers.
Contact a Pioneer Service Center or Pioneer Authorized Independent
Service company. These are listed on your warranty card for each
country or region.
Pin No.
Signal assignment
9
+5 V
10
GND (ground)
11
Not connected
12
SDA
13
HD
14
VD
15
SCL
Region
Lebanon
United Arab Emirates
Mexico
Chile
Brazil
Australia
New Zealand
Egypt
South Africa
Standard channel allocation
Normal
Normal
Cable (US Type)
Cable (US Type)
Cable (US Type)
Normal
Normal
Normal
Normal
12
49
En
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
