Watching Tv; Turning The Power On; Plasma Display Status Indicators - Pioneer PDP-507XG Manual De Instrucciones

Watching TV

Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner
must be set up. See Setting up TV channels automatically on
page 25 for how to do this.

Turning the power on

• To turn on the system, press POWER on the bottom-left of
the front of the plasma display.
The POWER ON indicator lights blue.
• To switch the system back into standby, press
remote control unit or STANDBY/ON on the plasma display's
control panel on the right-hand side.
The STANDBY indicator lights red.
PDP-507XG
POWER ON STANDBY
POWER ON STANDBY
POWER button
on the

plasma display status indicators

The table below shows the operational status of the plasma display.
You can check the current status of the system with the indicators
on the plasma display.
POWER ON indicator
STANDBY indicator
PDP-427XG
POWER ON
POWER button
• You can then turn on the system again by pressing
on the remote control or STANDBY/ON on the plasma display.
If you press 0 on the remote control unit, images come from the
INPUT 1 source. If you press 1 to 9, TV images display.
• You can also press POWER on the plasma display to turn off
the system. However, you cannot then turn on the system
again by pressing the buttons on the remote control unit or
STANDBY/ON on the plasma display.
Note
• If you are not going to use the plasma display for a long period
of time, be sure to remove the power cord from the power
outlet.
Indicator status
POWER ON STANDBY
The power cord of the plasma display has been
disconnected. Or, the power cord of the plasma
display has been connected but the POWER
button of the plasma display is off.
Power to the system is on.
The system is in the standby mode.
For other than the above, see Troubleshooting on page 48.
POWER ON indicator
STANDBY indicator
ST ANDBY
or 0 to 9
System status
06
19
En