Using The Hdmi Inputs; Connecting Hdmi Equipment - Pioneer PDP-507XG Manual De Instrucciones

Using with other equipment
Item Description
Always Output
Outputs composite video and audio signals no matter
which input source is selected.
INPUT 1 Prohibit Does not output composite video and audio signals
when INPUT 1 is selected.
INPUT 2 Prohibit Does not output composite video and audio signals
when INPUT 2 is selected.
INPUT 3 Prohibit
Does not output composite video and audio signals
when INPUT 3 is selected.
INPUT 4 Prohibit Does not output composite video and audio signals
when INPUT 4 is selected.
INPUT 5 Prohibit Does not output composite video and audio signals
when INPUT 5 is selected.
5 Press HOME MENU to exit the menu.
Note
• The INPUT 4 video signal is not output from the MONITOR OUT
jack regardless of this setting.

Using the HDMI Inputs

The INPUT 3 and INPUT 4 terminals include HDMI terminals to
which digital video and audio signals can be input. To use the
HDMI terminals, activate the terminal and specify the types of
video and audio signals to be received from the connected
equipment. For the types of these signals, see the operation
manual that came with the connected equipment.
Before starting the menu, press INPUT 3 or INPUT 4 on the remote
control unit or press INPUT on the plasma display to select INPUT
3 or INPUT 4.
Input signal correlation table
1920 x 1080i@50 Hz
720 x 576p@50 Hz
1280 x 720p@50 Hz
720(1440) x 576i@50 Hz
1920 x 1080i@59.94 Hz/60 Hz
720 x 480p@59.94 Hz/60 Hz
1280 x 720p@59.94 Hz/60 Hz
720(1440) x 480i@59.94 Hz/60 Hz
1920 x 1080p@24 Hz
For audio, the system supports the following:
• Linear PCM (STEREO 2ch)
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
Note
• PC signals are not compatible with the HDMI terminal.
• It may take a short while until the image is displayed,
depending on the equipment connected.

Connecting HDMI equipment

There are two HDMI inputs, labeled INPUT 3 and INPUT 4.
For INPUT 3, connect an HDMI cable for the video and (if
necessary) a stereo audio cable for analog audio. You can select
the audio and video format according to the device you've
connected – see below for more.
PDP-427XG (rear)
Stereo audio
cable
HDMI device
For INPUT 4, connect just an HDMI cable – this carries both the
audio and video signals.
PDP-427XG (rear)
3 4
HDMI cable carrying
the HDMI mark
3 4
HDMI cable carrying
the HDMI mark
HDMI device
10
43
En