Checking The Installation Position Of The Mowing Deck; Maintenance Interval; Changing The Wheels - Viking MR 4082 Manual De Instrucciones

Attach the mowing blade (1), screw in
blade fastening screw (2) with retaining
washer (3) (observe convexity of retaining
washer) and tighten to a torque of
65 - 70 Nm.
13.8 Checking the installation position
of the mowing deck

Maintenance interval:

Every 50 operating hours.
The mowing deck should be checked
every 50 operating hours or as required
(e.g. following severe impacts to the
mowing deck).
Risk of injury:
For all operations on the mowing
deck, stop the engine and remove
the ignition key.
Never reach under the mowing
deck when the blade is rotating.
106
Before checking the correct
installation position of the mowing
deck, the tyre pressures of all the
tyres must be checked and, if
necessary, adjusted. (
Differences in the tyre pressures
influence the positioning of the
mowing deck.
If the installed mowing deck is not
correctly positioned with respect to
the ground, the cutting pattern can
be negatively influenced.
The mowing deck is in the correct
installation position when front of the
mowing deck is slightly lower than the rear.
The mowing deck is tilted slightly forwards.
● Park the machine on level ground.
● Stop the engine. ( 11.3)
● Engage the parking brake. (
● Remove the ignition key and keep it in a
safe place.
● Select the lowest cutting level. (
Distance A = 10 mm.

13.9 Changing the wheels

In the case of damage (holes, cracks, cuts,
etc.) to the wheels, remove the damaged
13.25)
wheel and take it to a specialised dealer.
Lifting and supporting the machine
Risk of injury:
When lifting the machine, it must be
noted that it is very heavy (see
section "Technical specifications").
( 20.)
If necessary, raise the machine with
the help of a second person or
using a jack (not included in the
standard equipment).
Avoid damage to the machine
When supporting, ensure that only
the axle or the rear panel of the
8.9)
machine contacts the support.
Only lift the machine at suitable
components (e.g. frame, bumper,
rims, axle). Never lift or support the
8.10)
machine at plastic parts.
● Park the machine firm and level ground.
● Stop the engine. (
● Engage the parking brake. (
● Remove the ignition key and keep it in a
safe place.
11.3)
8.9)
0478 193 9901 A - EN