Standard Spare Parts; Accessories - Viking MR 4082 Manual De Instrucciones

– Position the loading ramps safely
(observe wheel base of the machine)
and secure.
– Ensure an even distribution of the load
on trailers.
– After loading, select the lowest cutting
level.
– Stop the engine.
– Push the machine fully forward until the
bumper contacts the front wall of the
trailer.
– Engage the parking brake.
– Close the fuel cock.
– Fasten the front bumper of the machine
to the front wall of the trailer using
suitable fastening material (straps,
ropes etc.), apply forward tension and
secure.
– Place additional wooden wedges (not
included in standard equipment) at the
wheels to prevent unintentional rolling.
118

15. Standard spare parts

Mowing blade:
6140 702 0100
Blade fastening screw:
9010 345 2430
Spring washer:
0000 702 6600
The fastening elements for the
mowing blade (e.g. blade fastening
screw) must be replaced when
replacing the blade, i.e. when
installing the blade. Spare parts are
available from a VIKING specialist
dealer.

16. Accessories

Additional accessories are available for
the machine.
Further information is available from your
VIKING specialist dealer, on the internet
(www.viking-garden.com) or in the
VIKING catalogue.
For safety reasons, only
accessories approved by VIKING
may be used with the machine.
0478 193 9901 A - EN