Insert the cutting height adjustment rod (3)
into the bore in the mowing deck mounting
(4).
Insert the retaining pin (1).
● Install the mowing deck. (
● Install the discharge chute. (
● Attach the grass catcher box. (
13.11 Checking the engine oil filling
level
Avoid damage to the machine.
Check the engine oil filling level
before initial use and before each
use.
110
● Park the machine on a flat, level
surface.
● Stop the engine. (
● Engage the parking brake. (
● Allow the engine to cool down.
● Open the storage compartment.
(
13.26)
Please consult the engine instruction
manual for instructions on checking the
engine oil filling level.
Note:
If there is insufficient or no engine
oil, the engine oil must be topped
up.
● Close the storage compartment.
(
13.26)
13.12 Changing the engine oil
Danger of burns!
Allow the engine to fully cool down
before topping up the engine oil
and before changing the engine oil.
Spilled engine oil may be ignited!
Exercise particular caution when
draining the engine oil. The engine
oil may be hot.
Information regarding engine oil
12.2)
and oil capacity can be found in the
13.4)
engine instruction manual.
Perform an oil change when the
11.9)
engine is warm to the touch. Place
a suitable oil collection container
(note engine oil capacity) under the
oil drain tube.
Dispose of used oil in conformance
with statutory requirements.
Oil change interval:
The recommended oil change intervals
11.3)
can be found in the engine instruction
manual.
8.9)
Draining the engine oil:
● Stop the engine. (
● Engage the parking brake. (
● Remove the ignition key and keep it in a
● Remove the discharge chute. (
● Allow engine to cool down (warm to the
● Open the storage compartment.
● Unscrew the oil cap (see also engine
MR 4082:
The oil drain hose (1) is located on the
engine, near the right-hand rear wheel.
● Place a suitable oil collecting container
● Detach the oil drain hose.
11.3)
safe place.
touch).
(
13.26)
instruction manual).
underneath.
0478 193 9901 A - EN
8.9)
13.3)