Opening And Closing Storage Compartment; Transport - Viking MR 4082 Manual De Instrucciones

13.26 Opening and closing storage
compartment
Opening the storage compartment:
Risk of injury:
Switch off the engine, remove the
ignition key and allow the engine to
cool down fully before opening the
storage compartment.
● Pull the driver's seat adjustment lever
upward and move the driver's seat to
the frontmost position (towards steering
wheel), or fold it forward.
Remove screws (1) by turning through 90°
anti-clockwise.
0478 193 9901 A - EN
Fold the storage compartment (2) up and
forward (toward driver's seat).
Closing the storage compartment:
Fold the storage compartment closed:
Press the screws (2) downward slightly
and hold.
Tighten the screws (2) clockwise (approx.
90°).

14. Transport

Risk of injury:
The section "For your safety",
especially subsection "Transporting
the machine" and subsection
"Instructions for safe operation of
the machine", must be carefully
read and observed.
When loading the machine onto a
suitable vehicle or a suitable trailer,
it must be ensured that the load is
distributed evenly.
When loading the machine, use
loading ramps which withstand the
weight and are wide enough to be
driven over safely. Select a low
driving speed when driving over the
loading ramps and ensure that the
wheels do not drive over the edges
of the loading ramps, resulting in
the ride-on mower falling to the
ground. Handle the vehicle
carefully and smoothly when driving
on slopes. Do not change speed or
direction abruptly.
On public roads, the machine may
only be transported by means of a
suitable vehicle or trailer. Do not
tow!
The following points must be noted when
transporting:
– Before loading, select the highest
cutting level.
– If a trailer is used, it must be supported
at the front so that it cannot tilt up due to
the weight of the machine.
– Use a suitable lifter or loading ramps for
loading the machine.
117