Installation Of The Slide; Basic Slide Master 2720 / 3020 / 3310; Vario Slice Slide / Vs Slide; Tilting Of The Vs-Slide - Graef Master 2720 Instrucciones De Servicio

4.1.2

Installation of the slide

• Insert the slide bolt into the bearing block.
• Press the slide onto the bearing block by hand.
• Tighten the knob on the base of the table.
Caution!
Danger of injury !
During installation there is a crushing risk.
Important!
The slide can only be removed, if the cutting thickness adjustment is turned clock-
wise up to the stop.
4.2.0

Basic slide Master 2720 / 3020 / 3310

6JG CTO QH VJG NCUV NKEG FGXKEG ECP DG UYKXGNGF WR CPF ZGF HQT KPUGTVKQP QH VJG RTQFWEV (1)
Subsequently it must be swiveled downwards again for cutting (optional).
Caution!
Danger of injury !
There is a crushing risk by falling down of the last slice device.
4.3.0 Vario-Slice Slide / VS-Slide
4.3.1

Tilting of the VS-Slide

• Switch off the machine
• Hold the table with your left hand by the black handle (1), so that your thumb is touching the bottom
round edge of the table.
• Press the black lever on the right (2) downwards, in order to unlock the slide.
48
(1)