Safety Of Laser Beam - Kyocera KM-4230 Manual De Instrucciones

SAFETY OF LASER BEAM

1. Safety of laser beam
This copier has been certified by the manufacturer to Class 1 level under the radiation performance
standards established by the U.S. DHHS (Department of Health and Human Services) in 1968.
This indicates that the product is safe to use during normal operation and maintenance. The laser
optical system, enclosed in a protective housing and sealed within the external covers, never
permits the laser beam to escape.
2. The CDRH Act
A laser-product-related act was implemented on Aug. 2, 1976, by the Center for Devices and
Radiological Health (CDRH) of the U.S. Food and Drug Administration (FDA). This act prohibits the
sale of laser products in the U.S. without certification, and applies to laser products manufactured
after Aug. 1, 1976.
The label shown below indicates compliance with the CDRH regulations and must be attached to
laser products marketed in the United States.
On this copier, the label is on the rear.
3. Optical unit
4. Maintenance
For safety of the service personnel, follow the maintenance instructions in the other section of this
manual.
5. Safety switch
The power to the laser unit is cut off when the front cover is opened.
213
<42 ppm>
COPYING MACHINE
4230
THIS PRODUCT COMPLIES WITH 21 60 Hz
CFR CHAPTER 1,SUBCHAPTER J.
U2
2-28 1-CHOME TAMATSUKURI CHUO-KU OSAKA JAPAN
MADE IN JAPAN
CAUTION ATTENTION
Double pole / neutral fusing. Double p
<52 ppm>
COPYING MACHINE
5230
THIS PRODUCT COMPLIES WITH 21 60 Hz
CFR CHAPTER 1,SUBCHAPTER J.
U2
2-28 1-CHOME TAMATSUKURI CHUO-KU OSAKA JAPAN
MADE IN JAPAN
CAUTION ATTENTION
Double pole / neutral fusing. Double p
When checking the optical unit, avoid direct exposure to the
laser beam, which is invisible.
Shown at left is the label located on the cover of the optical
unit.
MACHINE No. XV37
MANUFACTURED
120 V 10.5 A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
le / fusible sur le neutre.
Ô
MACHINE No. XW37
MANUFACTURED
120 V 10.5 A
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
le / fusible sur le neutre.
Ô
3 3 T 1
C US
LISTED
I.T.E.
3 3 T 1
C US
LISTED
I.T.E.