Hanging Installation - Carel huniDisk Serie Manual Del Usuario

humiDisk
65
To install the humidifi er on the wall, use the bracket and the screws supplied. The bracket can be used
as a template to mark the holes on the wall. Maintain the distances indicated in paragraph 2.3, and make
sure that the bracket is level before drilling the holes. Make sure that the wall can support the appliance in
normal operating conditions.
• Drill four 8 mm dia. holes, 45 mm deep, in the wall as shown in Fig. 2.i;
• clean the inside of the holes;
• insert the four screw anchors while keeping the two expansion tabs vertical;
• fasten the bracket.
The bracket must be fi tted as shown in Fig. 2.l.
Once the bracket has been fastened to the wall with the four screws, carry out the following operations,
as shown in Fig. 2.m:
• Lift the appliance and tilt it slightly towards the wall.
• Move the appliance until the brackets fi t into place.
• Let the appliance roll down, while guiding it, to the horizontal position: at this point the brackets should
be perfectly coupled and interlocked.
• Insert the safety screw supplied that joins the two brackets and that prevents the appliance from acci-
dentally becoming dislodged.
120 mm
Fig. 2.i

2.5 Hanging installation

Hanging installation is performed using the standard brackets supplied.
Three supporting chains must be prepared for hanging the appliance.
The chains must hang down as straight as possible and be attached to hooks that can bear the weight of
the appliance (see Fig. 2.n and paragraph 10).
Use metal, possibly steel chains, and at any rate material that is not affected by humidity. Maintain the
minimum distances indicated in Tab. 2.a.
For the humiDisk use the brackets supplied, hooking one side onto the holes at the bottom and the other
10
to the chains hanging from above.
For the humiDisk remove the rear bracket A, for wall mounting, as shown in Fig. 2.p, by unscrewing the
65
four screws V.
Now there should be fi ve (5) screws available (4 screws removed from the plate A, and 1 safety screw,
supplied) each with its own washer.
Replace 2 screws in the holes F indicated in Fig. 2.p.
Use 3 screws to fi t the brackets for hanging installation as shown in Fig. 2.q.
The brackets have been designed to allow the removal of the fi lter, so that normal maintenance operations
can be carried out without having to unhook the appliance from the supporting chains.
Hook the appliance to the chains and at the same time check that it is in a horizontal position.
3 mm
<
Fig. 2.o
humiDisk - +030222022 - rel. 2.1 - 01.03.2012
Fig. 2.p
Fig. 2.l
Fig. 2.q
11
Fig. 2.m
Fig. 2.n