Cleaning; Pressure Control Assembly / Disassembly - Profi Cook PC-SKT 1071 Instrucciones De Servicio

Fish (approx. 1000 g)
Sole
Tuna (steaks)
The easiest way to clean the pressure cooker is directly after use.
1. Wait until the metal parts have cooled down.
2. Remove the sealing ring from the lid.
3. Clean the parts as usual by hand in soapy water.
• Do not use sharp or abrasive tools.
• Burnt residue can be removed with a cleaning sponge.
• The cooker can also be cleaned in the dishwasher.
4. Dry all parts.
5. At the end, check if the valves are free from any residue.
6. Reinstall the sealing ring.
It might be necessary to remove the pressure control for maintaining or cleaning. In order to do so, you
need a SW13 screw-wrench and on top of that require some technical know-how and craftsmanship. Ask
for help if necessary.
Disassembly
1. Turn the lid over and loosen the cap nut including the O-ring located underneath.
2. Lift the pressure control up. Careful with the seal!
3. Separate the button from the valve by turning and pressing.
Assembly
4. Once you have cleaned or replaced the parts, you can assemble the button and the valve again by
turning and pressing.
NOTE:
The button and valve only match in one direction.
5. Place the bigger seal in the lid from above with the side of the groove facing down.
6. Reinstall the pressure control. Use the profile in the lid.
7. First apply the O-ring to the thread of the pressure control.
8. Then attach the cap nut.
9. Gently tighten the cap nut using the screw-wrench.
10. The pressure control must turn with little resistance.
11. If not, readjust the cap nut.
82

Cleaning

Pressure control assembly / disassembly

Cooking method
BIO
BIO
Cooking time
(approx. min.)
10
13