Roland JUNO-G Manual Del Usuario página 220

MIDI Implementado
3.2 Messages not recorded during recording
IChannel mode messages
GLocal On/Off (Controller number 122)
Status 2nd byte
BnH 7AH
n=MIDI channel number:
vv=Value:
GAll notes off (Controller number 123)
Status 2nd byte
BnH 7BH
n=MIDI channel number:
* When an All Note Off message is received, all notes of the corresponding channel that
are on will be sent Note Off's, and the resulting Note Off messages will be recorded.
3.3 Messages acknowledged for synchronization
ISystem Common messages
GTune Request
Status
F6H
GMIDI Time Code Quarter Frame Messages
MIDI Time Code Quarter Frame Messages can be transmitted while the sequencer is
running (Playing or Recording) if the Sync Mode parameter (SYSTEM/TEMPO/SYNC) is
MASTER and MTC Sync Output parameter (SYSTEM/MIDI/MMC MTC) is ON. The
transmitted time counts are summed to MTC Offset Time parameter (SYSTEM/MIDI/
MMC MTC) as the song top is "00:00:00:00."
The sequencer synchronizes with the time counts which are summed to MTC Offset Time
parameter (SYSTEM/MIDI/MMC MTC) as the song top is "00:00:00:00" if the Sync Mode
parameter (SYSTEM/TEMPO/SYNC) is SLAVE(MTC).
Status Second
F1H mmH (= 0nnndddd)
nnn = Message type :
0 = Frame count LS nibble
1 = Frame count MS nibble
2 = Seconds count LS nibble
3 = Seconds count MS nibble
4 = Minutes count LS nibble
5 = Minutes count MS nibble
6 = Hours count LS nibble
7 = Hours count MS nibble
dddd = 4 bit nibble data : h - FH (0 - 15)
Bit Field is assigned as follows.
Frame Count xxxyyyyy
xxx Reserved (000)
yyyyy Frame No.(0-29)
Seconds Count xxyyyyyy
xx
yyyyyy
Minutes Count xxyyyyyy
xx
yyyyyy
Hours Count xyyzzzzz
x
yy
0 = 24 Frames / Sec
1 = 25 Frames / Sec
2 = 30 Frames / Sec (Drop Frame)
3 = 30 Frames / Sec (Non Drop Frame
zzzzz
GSong Position Pointer
Status 2nd byte
F2H mmH
mm, ll=value: 00 00H - 7F 7FH (0 - 16383)
220
3rd byte
vvH
0H - FH (ch.1 - ch.16)
00H, 7FH (Local Off, Local On)
3rd byte
00H
0H - FH (ch.1 - ch.16)
Reserved (00)
Seconds (0-59)
Reserved (00)
Minutes (0-59)
Reserved (0)
Time Code type
Hours (0-23)
3rd byte
llH
ISystem Realtime Messages
GTiming Clock
Status
F8H
* Received when Sync Mode parameter (SYSTEM/TEMPO/SYNC) is set to SLAVE-MIDI.
GStart
Status
FAH
* Received when Sync Mode parameter (SYSTEM/TEMPO/SYNC) is set to SLAVE-MIDI
or REMOTE.
GContinue
Status
FBH
* Received when Sync Mode parameter (SYSTEM/TEMPO/SYNC) is set to SLAVE-MIDI
or REMOTE.
GStop
Status
FCH
* Received when Sync Mode parameter (SYSTEM/TEMPO/SYNC) is set to SLAVE-MIDI
or REMOTE.