Nozzle List - SATA jet 4800 K spray mix Instrucciones De Servicio

Warning!
Risk of injuries from components coming loose or leaking
material.
If cleaning work is performed while the gun is still connected to the com-
pressed air circuit and material supply, components can unexpectedly
work loose and material can leak.
→ Disconnect the spray gun from the compressed air circuit and the
material supply before any cleaning work.
Attention!
Damage from wrong cleaning agents
The use of aggressive cleaning agents can damage the spray gun.
→ Do not use aggressive cleaning agents.
Only use suitable cleaning solutions for cleaning.
→ Use a neutral cleaning solution with a pH of 6–8.
→ Do not use acids, caustic solutions, bases, paint strippers, unsuitable
regenerates or other aggressive cleaning agents.
There is a risk of corrosion if the spray gun is submerged in the cleaning
solution.
→ Do not submerge the spray gun in cleaning solution.
Incorrect cleaning tools can damage the holes and impair the spray fan
pattern.
→ Only use the SATA cleaning brushes.
→ Never use ultrasonic cleaners.

12. Nozzle list

Fluid tip
Nozzle Art.
No. No.
1840 23044
2325
Operating instructions SATAjet 4800 K spray mix
Technical Data
Ø mm Ø inch Angle
0,18
7328 0,23
0,007 40°
0,009 25°
Width Flow rate
cm SL/min
at 70 bar
(1015 psi)
18 0.16
14 0.23
EN
159