Using The Multitest Med. Int - Dräger HP Instrucciones De Uso

Using the MultiTest med. Int.

Insert tube
The following media can be tested:
O , Air, CO , N O and N .
2 2 2 2
Two signs can be found on the measuring device:
Sign 1
O Air
2
Sign 1 specifies the media that can be tested. A colour can be found under
the testable media.
Sign 2
Oil CO SO
2 2
Sign 2 specifies the substances that can be detected. A sequence of
colours is located above each substance.
Visit: www.thesafetyequipmentstore.com or email besafe@thesafetyequipmentstore.com for sales and service.
28
CO N O N
2 2 2
H S NO CO H O
2 x 2
Example:
Measuring the O supply
2
Sign 1
– The colour white is shown be-
low the O symbol.
2
For test times, see the table
(see "Table of measurement
recommendations/limit values
for MultiTest" on page 29).
Sign 2
Fit the measuring device with the white test tube (here CO
H O).
2
Oil CO SO
2 2
Break off the Dräger tubes as described, see "Prepare Dräger tube" on
page 25 and insert them in the Dräger tube holder in the direction
shown by the arrow.
Pull on the bottom end of the Dräger tube container until the Dräger
tube can be completely inserted in the Dräger tube holder.
O Air
2
, CO and
2
H S NO CO H O
2 x 2